BIOS BEEP ERROR CODE LIST:

ID Problem Description Problem Solution
1 No Beep or no sound Power supply bad or not plugged in.
2 Continuous beep Power supply bad or bad keyboard
3 2 short beeps with a Compaq This is normal with desktop and most older laptop models.
4 Repeating short beep Power supply bad
5 One short beep This is normal on many computers (no error)
6 1 long beep, 1 short beep Motherboard failure
7 1 long beep 2 short beeps Failure of video display or cable could be unattached
8 1 short beep, blank screen Failure of display or unattached cable
9 1 short beep with no boot Floppy drive failure or loose cable
10 2 short beeps PS2 only Configuration error, check jumpers.

POST ERROR CODE DETAIL:

POST Code Problem Solution
02x Power supply error
1xx System board error
101 Interrupt failure, probably replace motherboard
102 Timer failure, check timing jumpers
103 Timer interrupt failure check jumpers
104 Protected mode failure reload dos
105 Last 8042 command not accepted
106 Converting Logic test error, possible bad processor
107 Hot NMI Test
108 Failure with the timer bus test, check timing jumpers
109 Direct memory access test error
121 Unexpected hardware interrupt, check jumpers on attached devices
161 AT Battery failure, replace CMOS battery
162 Rerun Setup
163 Time and date not set
164 Memory size error, run setup
165 PS2 doesn't know how to configure board, put in setup disk
199 User indicated configuration not correct, check jumpers
2xx RAM error, test memory with external device
201 Memory test failed, probably bad RAM
202 Memory address error
203 Memory address error
3xx Keyboard errors, try replacing keyboard
301 Keyboard error, try replacing keyboard
302 Key lock locked on CPU, unlock unit with key
303 Keyboard or system unit error, try replacing keyboard
304 CMOS does not match system, rerun setup
4xx Monochrome monitor errors, check adapter card
401 Adapter memory error, replace card
408 User indicated display attributes failure
416 Character set failure
424 80x25 mode failure
432 Parallel port failure
5xx Color monitor errors
501 Color adapter memory, horizontal sync frequency or video test failed. Replace card or test Monitor board (Not recommended without electrical training)
508 Display attributes failure
516 Character set failure
524 80x25 mode failure
532 40x25 mode failure
540 320x200 mode failure
548 640x200 mode failure
6xx Diskette drive controller failure. Replace motherboard if on board directly or replace with an ISA card.
601 Adapter or drive failure of post for floppy drive
602 Diskette failed post or boot record is not valid
606 Diskette verify function failed
607 Write protected disk
608 Bad command diskette status returned
610 Diskette initialized failure
611 Timeout
612 Bad NEC chip on disk controller
613 Adapter failed DMA test for diskette
621 Bad seek
622 Bad CRC found
623 Record not found
624 Bad address mark
625 Bad NEC seek
626 Diskette data compare error
7xx Math Coprocessor errors
9xx Printer adapter errors
1101 Asynchronous. (rs232) adapter failure com 1 or 3
1201 Asynchronous. (rs232) adapter failure com 2 or 4
13xx Game port failure
1301 Game adapter test failed
1302 Joystick test failed
14xx Printer errors
1401 Printer test failed
1402 Dot Matrix printer test failed
15xx 1500’s Terminal synchronization Failure
1513 8253 timer 1 did not reach terminal count
1514 8252 timer 1 stuck
1515 8253 timer 0 did not reach terminal count
1514 8253 timer 1 stuck on
1516 8253 timer 0 stuck on
1517 8253 Timer 2 did not reach terminal count
1518 8253 timer 2 stuck on
1519 8273 Port B error on
1520 8273 Port A error
1521 8273 Command read timeout
1522 Interrupt level 4 failure
1523 Ring indicate stuck on
1524 Receive clock stuck on
1525 Transmit clock stuck on
1526 Test indicate stuck on
1527 Ring indicate not on.
1528 Transmit clock not on.
1531 Data set ready not on
1532 Carrier detect not on.
1533 Clear to send not on.
1534 data set ready not on.
1536 Clear to send stuck on.
1537 Level 3 interrupt failure
1538 receive interrupt results error
1539 Wrap data comparison failure
1540 DMA Channel 1 error
1541 Error in 8273 error check or status reporting.
1547 Stray Interrupt level 4.
1548 Stray interrupt level 3.
1549 Interrupt presentation sequenced timed out.
16xx Terminal emulation errors.
17xx Hard disk/disk controller errors.
1701 Hard drive POST error
1702 Adapter failure hard drive.
1703 Hard drive failure.
1704 Hard drive adapter failure: Cannot be determined
1780 Hard drive failure
1781 Drive 1 failure (D drive)
1782 Hard drive adapter failure.
1790 Hard drive C failure-couldn’t read last cylinder.
1791 D drive failure
18xx Expansion chassis failure.
1801 POST error code
1810 Extender card failure.
1811 Extender card failure
1812 Address or wait state failure.
1813 Address or wait state failure
1816 Extender card failure.
1819 Wait request switch set incorrectly.
1820 Receiver card failure.
1821 Receiver card failure.
19xx 3270 PC com controller failure.
20xx BSC adapter (Mainframe connection) failure.
2010 Failure of 8255 Port B
2011 Failure of 8255 Port A
2012 Failure of 8255 Port C
2013 8253 Timer one did not reach terminal count.
2014 8253 Timer 1 stuck on
2015 8253 Timer 0 did not reach terminal count.
2016 8253 Timer 0 stuck on
2017 8253 Timer 2 did not reach terminal count.
2018 8253 timer 2 stuck on
2019 8273 Port B error.
2020 8273 Port A error.
2021 8273 command/read time out.
2022 Interrupt level 4 failure.
2023 Ring indicates stuck on.
2024 Receive plot stuck on.
2025 Transmit clock stuck on.
2026 Test indicate stuck on.
2027 Ring indicate not on.
2028 Receive clock not on.
2029 Transmit clock not on.
2030 Test indicate not on.
2031 Data set ready not on.
2032 Carrier detect not on.
2033 Clear to send not on.
2034 Data set ready not on.
2036 Clear to send stuck on.
2037 Level 3 interrupt failure.
2038 Receive interrupt results error.
2039 Wrap data compare failure.
2040 DMA channel 1 error.
2041 Error in 8273 error check or status reporting.
2047 Stray interrupt level 4.
2048 Stray interrupt level 3.
2049 Interrupt presentation sequence time out.
21xx Alternate BSC adapter failures.
2201 Pc wiring cluster adapter failure.
2401 EGA/VGA failure: May show text but not graphics.
2901 Color dot matrix failure.
3301 Compact printer failures.
86xx Mouse error.